Replace Brake Light

Place them off to the side with the screws.

Replace brake light. If all the lights are not working it may be due to a faulty brake switch. Check out all the lighting parts available on napa online or trust one of our 17 000 napa autocare locations for routine maintenance and repairs. The plug also screws into the light assembly. Turn the brake light bulb a quarter turn counterclockwise.

Identifying the correct light bulb. The lights are held within the brake light case on the rear of the car. If your assembly is inaccessible or complicated take your vehicle to your local napa autocare to replace the brake light. The ford focus also has a third brake light which is also known as a center high mounted brake light.

Brake light bulbs are located at the back of the car housed inside a protective covering lens. Brake light bulb replacement service what is the brake light bulb all about. Removing the brake light bulb. You will hear the socket click.

This supplies the switch with power. Disconnect the connector on the switch by sliding it off the contact. This will unlock the bulb from the socket. Follow the wires to the back of the light that you need to replace that s the bulb holder you want to unscrew or rather pull out.

To remove the brake light bulb make sure the lights are off and the bulb is cool to the touch. While diagnosing brake light issues keep in mind that the brake switch controls all three lights. Remove the brake light socket by turning it counterclockwise. Turn counterclockwise to remove.

The new brake light switch is very easy to install. The brake light turns on when you push the brake pedal letting drivers know that you are slowing down. Pull the socket out. Insert a replacement brake light bulb and rotate it clockwise until you hear it lock into place.

The bulbs in your brake light or taillight assembly are held in place using a plug that holds the bulb. Remove the brake light bulb from the socket by pulling it out. After the brake light bulb is removed take a look at the numbers on the bulb and match them to the new bulb. Watch more how to make simple car repairs videos.

The ford focus standard brake lights are owner replaceable. A connector or plunger moves with the brake pedal and bridges the gap between both sides of the circuit allowing power to flow and light up the brake lights. This case also stores the turn signal and reverse light. Remove the bulb from the taillight assembly and discard it.

Install the new brake light bulb into the socket. Pull the brake light bulb out of the socket. The bulb socket has a release tab. Step 4 replace the brake light switch.