How To Change Brake Light

Apply dielectric grease to the brake light bulb socket.

How to change brake light. Remove the brake light switch from the bracket. This supplies the switch with power. Remove the bulb from the taillight assembly and discard it. Push the cover back in its place and replace the two plastic phillips screws.

A connector or plunger moves with the brake pedal and bridges the gap between both sides of the circuit allowing power to flow and light up the brake lights. Learn how to replace the brake tail light blinker and reverse light bulbs on a 2008 2012 honda accord sedan. Remove the bottom plastic trunk panel. In the trunk compartment reattach and tighten the two nuts.

While diagnosing brake light issues keep in mind that the brake switch controls all three lights. This will unlock the bulb from the socket. Set the brake light case in its mount. Gain access to the bulb.

If your brake light switch has a red or white collar you will need to slide that out then press the tabs and release the brake light switch. Disconnect the connector on the switch by sliding it off the contact. There will be one or two tabs that you need to press which will release the brake light switch. Identifying the correct light bulb.

The plug also screws into the light assembly. After the brake light bulb is removed take a look at the numbers on the bulb and match them to the new bulb. The new brake light switch is very easy to install. Watch more how to make simple car repairs videos.

How to replace brake light switch on a harley diagnosing front brake switch problems harley riders usa forums front brake light lever contact archive the sportster and buell fix front brake switch front brake switch issue 1130cc com the 1 harley davidson v rod harley front brake light switch labrit co. Press the connector and unplug the wire harness from bmw brake light switch. Fortunately these are pretty easy to change and barely require any tools. Insert a replacement brake light bulb and rotate it clockwise until you hear it lock into place.

Remove the plastic trim screw that keeps the carpeting in place. To remove the brake light bulb make sure the lights are off and the bulb is cool to the touch. Pull the brake light bulb out of the socket. Start by pressing the brake pedal.

Place them off to the side with the screws. The brake switch does exactly this action when you press on the brake pedal. You can now remove the brake light switch covers and see the actual switch. Step 4 replace the brake light switch.